Epoxy Floors North Hollywood

An epoxy floor gives an apartment or condo property in North Hollywood one sealed, seamless surface that carries everyday traffic and cleans without a special routine. Most multifamily work splits between two systems: solid color epoxy where residents park, and a flake finish through the spaces they walk.

(310) 270-3256 GET A FREE QUOTE

Clean empty garage with light gray epoxy flake flooring and beige walls.

What an Epoxy Floor Gives an Apartment Property

The gain is a floor that stays presentable with very little done to it. The system we use most on resident parking is made with 100% solids, so the coating goes on thick and grips properly prepared concrete rather than sitting on top of it. Hot tires, dripped oil and the constant in and out of vehicles are what it is built to shrug off, and the surface is seamless and non porous, so dirt has nowhere to settle.

Appearance is the second gain, and on a shared property it counts for more than people expect. The colors run light and reflective, so a parking level finished in one stops reading as a basement and starts reading as part of the building. For a board weighing improvements, few of them get seen by every resident twice a day, and this one is protecting the concrete underneath while it is doing it.

That build is solid color epoxy, and it is the same specification that goes into a private garage flooring job, laid at building scale instead. For whoever manages the property the practical benefit is low maintenance: the surface is sealed, so cleaning it stays a routine job rather than a restoration one.

(310) 270-3256 GET A FREE QUOTE

Commercial Garage Floor Coating In Los Angeles

From Resident Parking to the Common Areas

Resident parking is the largest single floor on most of these properties and the one doing the hardest work: vehicle traffic, storage stacked along the walls, and people walking through it in every kind of shoe. It is also the space that sets the tone for everything else, because it is where residents and their visitors arrive.

Apartment and HOA common areas and parking structures are part of our commercial flooring work, which makes a multifamily property ordinary for us rather than a special case. North Hollywood has a lot of the buildings it suits: two and three story blocks sitting over tuck-under parking, built close together off Lankershim and Magnolia, with a garage that every resident crosses twice a day.

Entry lobbies, corridors, stair landings, mail and bike rooms and the shared laundry take constant foot traffic and almost no vehicle load, so the priority moves to traction and appearance. Storage rooms, trash and recycling rooms and the utility space behind the garage sit at the other end again: a heavier chemical load, very little foot traffic, and specified for cleanability rather than looks.

Where a surface carries people rather than cars, a flake flooring finish is the better fit, because its broadcast texture gives a slight anti slip finish underfoot and reads as decorative rather than industrial. Balconies and exterior walkways are a different specification again, and quartz is usually where those land: chemical and abrasion resistant, UV stable, with an anti slip texture.

(310) 270-3256 GET A FREE QUOTE

Built for a Floor Everyone Shares

A floor in a shared building is chosen by one person and lived on by everyone else. The manager or the board signs it off, residents and their guests use it every day without giving it a thought, and a cleaning contractor maintains it on a schedule with the same equipment in every space. Nothing about it depends on an owner looking after their own floor, which makes specifying for a property a different exercise from specifying for a private garage.

So what matters is the build underneath rather than the finish on top. What we are choosing for is a surface that gets constant use and no individual attention, which points at how the coating is made rather than what it looks like on the day it goes down.

Our flake systems put a high-build epoxy underneath to do the adhesion and take the impact, then a polyaspartic clear topcoat over it to carry the abrasion resistance, which puts the hardest layer in the system exactly where the scuffing happens. Flake and polyaspartic are not competing choices here: the polyaspartic is what a flake floor is finished with.

(310) 270-3256 GET A FREE QUOTE

Clean garage interior with newly installed gray flake epoxy floor, white walls, partially open ceiling, and American flag on the wall.

Serving North Hollywood and the East Valley

Rise Coatings works across North Hollywood, from the NoHo Arts District down through the blocks around Chandler and out to the residential streets toward Burbank. We coat resident parking, private garages, entry areas and shared rooms for apartment and condo properties right across the East Valley. Work is quoted from a walkthrough and the estimate is free and done on site. We also work in Van Nuys, Sherman Oaks, Glendale and Arcadia. More about our solid color epoxy flooring.

Contact us today for a consultation and discover how epoxy flooring can elevate your space.

(310) 270-3256 GET A FREE QUOTE

Contact Rise Coatings

Give us a call if you have any questions related to our flooring services, if you would like to inquire about a large flooring project or would like to receive a complimentary onsite estimate.

info@risecoatings.com

+1 (310) 270-3256

8335 Winnetka Ave #178, Winnetka, CA 91306

CSLB # 1108031

Get Your Free Estimate

Thank you for contacting Rise Coatings. One of our representative will get back to you as soon as possible.

Oops! Something went wrong while submitting the form.